Panasonic CQ-C9901W, C9801W operating instructions General, Motion Open/Close, Tilt, Face Plate

General

This chapter explains how to turn on or off the power, how to adjust the volume, etc.

	Power on
	Press [SRC] (PWR: POWER).	SRC	CS
	Notes:
	¡ The opening screen appears. You can overwrite the
On/offPower POWER)(PWR:	opening screen (moving picture) with new one. (a
	page 36)
	¡ When the power is switched on for the first time, a
	demonstration message appears on the display. Press
	[DISP] to change to regular mode. (a page 10)
	Power off
	Hold down [SRC] (PWR: POWER) for 2
	sec. or more and release it.
	Note: The ending screen appears. You can overwrite the
	ending screen (moving picture) with new one. (a page
	36)

You can remove the face	3 Put the face plate in the case.
plate to prevent it from
being stolen.
Removing	Mounting
	1 Slide the left side of the face plate in
1 Turn off the power (a page 12)

Motion (Open/Close, Tilt)	(OPEN/CLOSE, TILT)
Face Plate

Open/Eject

Press [ ] (OPEN).			English
When a disc is already loaded, the disc will automatically
be ejected.	SRC	CS
Caution	Tilt		General
	The display angle changes among 4 levels as follows
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.	every time you hold down [ ] (TILT) for 1 sec. or
¡ Do not pinch your finger or hand in the face plate.	more and release.

¡ Do not insert foreign objects into the disc slots.

¡For the following cases, the face plate automatical-

ly closes. Use caution not to catch your finger. ¡ After a lapse of 20 seconds

¡ When a disc is inserted

¡ When the face plate is removed (a page 12)

¡Five seconds after turning off the power or turning the key to ACC OFF.

Close	Note: The last selected	TILT 1
	angle is maintained even
		TILT 2
	after turning off the power.	TILT 3
Press [		OPEN
	] (OPEN).
		TILT OFF

q Up

w Down

Removing/Mounting		2 Press [	place.
			] (Release).
		(The face plate disengages
		with a click when it is
		removed.)
	THEFT)	The face plate automati-
		cally closes in 5 sec-

Volume Adjustment (VOLUME)

Setting Range: 0 to 40

Default: 18

Notes:

¡The volume level can be set independently for each source. (For radio, one volume setting for AM, one volume setting for all FMs)

¡The volume is not adjustable while an error appears on the monitor or the external mute function is enabled. (a page 42)

(ANTI-	onds if it is open or tilt-	2 Press the right end of the face plate
	ed.
Plate	Note: The power is automatically turned off while	until “click” is heard.
	the unit is active.
Face	Caution
	¡ It is recommended to remove or mount the face	¡ Do not touch the contacts on the face plate or on the
	plate when the plate is at the closed position.	main unit, since this may result in poor electrical
	Do not remove or mount the face plate when the	contacts.
	plate is in motion.	¡ If dirt or other foreign substances get on the con-
	¡ This face plate is not waterproof. Do not expose it to	tacts, wipe them off with clean and dry cloth.
	water or excessive moisture.	¡ To avoid damaging the face plate, do not push it
	¡ Do not remove the face plate while driving your car.	down or place objects on it while it is open.

¡Do not place the face plate on the dashboard or nearby areas where the temperature rises to high levels.

Temporary Volume Off (Down) MUTE (ATT: ATTENUATION)

Volume off (down)

Press [ ] (MUTE).

SRCCS

Cancel

Press [] (MUTE) again.

Note: Volume-down range can be specified. (a page 34)

12 CQ-C9901W/C9801W CQ-C9901W/C9801W 13