Panasonic CQ-R223W Anti-Theft System, Place the Removable Face Plate into Case, Wiring Diagram

N

E Anti-Theft System

G

L

I

SThis unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable.

H

Electrical Connections	E
	N
	G
	L
	I
Preparation:	S
• This unit can be connected to an optional CD changer (CX-DP88). For details consult your nearest Panasonic Service	H

13

Place the Removable Face Plate into Case

Switch off the power of the unit.

Remove the removable face plate. (➡ page 23)

Gently press the bottom of the case and open the cover. Place the face plate into the case and take it with you when you leave the car.

Removable face plate case

center. 14

•For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-DP88).

Cautions:

•This product is designed to operate with a 12 V DC, negative ground battery system.

•To prevent damage to the unit, be sure to follow the connection diagram below.

•Strip about 5mm of the lead ends for connection (only non-ISO connector cords).

•Do not insert the power connector into the unit until the wiring is completed.

•Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts.

•Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected.

Install Removable Face Plate

Slide the left side of the removable face plate in place. Press the right end of the removable face plate until “click” is heard.

Tab
	DOLBY	B NR
CQ-R	223W
Cutout

❐Wiring Diagram

Extension Cord

Supplied for an optional CD changer (DIN/BATT/RCA/GND)

Fuse(3A)
BATTERY		Battery Lead
		To the car battery, continuous
		+12V DC
RCA Cord		(L)
		(White)
	(Red)	CD Changer
DIN Cord	(R)	Control Connector

CD Changer

CX-DP88

(Option)

Ground Lead

To a clean, bare metallic part of your car

Cautions:

•This face plate is not waterproof. Do not expose it to water or excessive moisture.

•Do not remove the face plate while driving your car.

•Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level.

•Do not touch the contacts on the face plate or the main unit, since this may result in poor electrical contacts.

•If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.

Antenna

(White w/Black Stripe)

(–)

CQ-R223W

Fuse (15 A)

• If the fuse (rear panel) blows

CD•C-IN

frequently,there may by something

wrong with the unit, Consult the shop

L(White)

where you purchased this unit.

R(Red)

Power

Connector

Battery Lead

Pre-Amp. Out Connector

To the car battery, continuous

(Rear)

(Yellow)

+12V DC

BATTERY 15A

ACC Power Lead

(Red)

To ACC power, +12V DC

ACC

Ground Lead

(Black)

To a clean, bare metallic part of

the car chassis

(Blue)

Not Used

(Blue w/White Stripe)

SPEAKER LEAD

External Amplifier

(Gray w/Black Stripe)

(Violet w/Black Stripe)

Control Power Lead

To an external amplifier

FRONT SP

REAR SP

Note: This lead is used for power

(White)

(Gray)

(Green w/Black

(Green)

(Violet)

Stripe)

control when an external power

amplifier is connected. The power

(–)

(+)

(–) (+)

supply of a power amplifier will be

(+)

(–) (+)

activated when turning on the power of

this unit.

24

CQ-R223W

LEFT SPEAKER	RIGHT SPEAKER	LEFT SPEAKER	RIGHT SPEAKER
(FRONT )	(FRONT )	(REAR )	(REAR )

CQ-R223W

25