Panasonic CS-MKS24NKU, CS-MKS9NKU Removing and Installing the Grille 3-4-1. Indoor unit types

3-4. Removing and Installing the Grille

3-4-1. Indoor unit types

(CS-MKS7NKU, CS-MKS9NKU, CS-MKS12NKU)

Basically, these models can be installed and wired without removing the grille. If access to any internal part is needed, follow the steps as given below.

Air intake grille Grille

CAUTION

Be sure to wear work gloves during installation to avoid being cut by the sharp aluminum fins of the heat exchanger.

Fig. 16a

How to remove the grille

(1)Grasp both ends of the air intake grille, and remove it by opening towards the front and pulling towards you. (Fig. 16a)

(2)Remove the 2 screws. (Fig. 16b)

(3)Remove the screw on the right side cover plate and open the cover. (Fig. 17a)

(4)Take out the thermistor from the grille. (Fig. 17b)

(5)Pull the lower part of the grille toward you to remove. (Fig. 18a)

(6)Use a standard screwdriver to push on the tabs to remove the grille.

How to replace the grille

(1) Reinstall the grille into the lower part while aligning its tabs on the upper part. (Fig. 18b) Insert the tabs in the slots and push the lower part of the grille back into position.

(2)Make sure that the grille and frame are firmly fitted together by engaging the tabs.

(3)Attach the thermistor on the grille. (Fig. 17a)

(4)Close the cover and replace the screw. (Fig. 17a)

(5)Affix the grille with the 2 previously removed screws.

(Fig. 16b)

(6) Install the air intake grille.

(a)Allow the edge of the air intake grille to slide into the top of the indoor unit, and then insert it all the way inside. (Fig. 19a)

(b)Press the bottom right and left corners of the air intake grille to attach it to the indoor unit. (Fig. 19b)

NOTE

Attach so that the round pins at the top right and left corners of the air intake grille are inserted into the grooves at the top right and left of the

indoor unit.

Fig. 19b

9

Screw cover

Fig. 16b

Cover

Thermistor

Thermistor

Fig. 17a Fig. 17b

Tab

*

* Grille

Frame

Tab

Fig. 18a

*

*

Fig. 18b

Groove

Pin

Fig. 19a