– 12 –
Chargement des paramètres du téléviseur dans la boîte de clonage (LEARN)1. Appuyer sur la touche POWER ON de la boîte de
clonage.
• Les diodes clignotent (vert et rouge) pour
confirmer la mise en marche.
2. Brancher la boîte de clonage dans le port
d’interface numérique sur le panneau arrière du
téléviseur.
• Le téléviseur doit être sous tension (cordon
branché) mais peut être en ou hors marche.
3. Tout en maintenant la touche ALT enfoncée,
appuyer sur la touche LEARN.
• La diode rouge clignote pendant le
chargement des données. La diode verte
s’allume pendant environ deux (2) secondes
une fois le chargement terminé.
Nota: Le téléviseur passe dans le mode HÔTEL.
4. Débrancher la boîte de clonage du téléviseur, puis
la mettre hors marche.
Nota: Les données sont conservées en mémoire
même si la batterie est retirée.
Téléchargement des paramètres sur d’autres téléviseurs (TEACH)1. Appuyer sur la touche POWER ON de la boîte de
clonage.
• Les diodes clignotent (vert et rouge) pour
confirmer la mise en marche.
2. Brancher la boîte de clonage dans le port
d’interface numérique sur le panneau arrière du
téléviseur.
• Le téléviseur doit être sous tension (cordon
branché) mais peut être en ou hors marche.
3. Appuyer sur la touche TEACH.
• La diode verte clignote pendant le chargement
des données. La diode verte s’allume
pendant environ deux (2) secondes une fois le
chargement terminé.
Nota: Le téléviseur passe dans le mode HÔTEL.
4. Débrancher la boîte de clonage du téléviseur, puis
la mettre hors marche.
5. Recommencer les étapes 1 à 4 aussi souvent que
nécessaire.
Uploading Television Settings into the Clone Box (LEARN)1. Press the POWER ON button on the clone box.
• The LEDs will flash red and green to confirm
power is ON.
2. Connect the clone box to the Digital Interface port
on the back of the television.
• The television must be plugged into an AC
outlet but can be either OFF or ON.
3. Hold the ALT button while pressing the LEARN
button.
• The red LED will flash while the data is
uploaded to the box. The green LED will light
for about two (2) seconds when the procedure
is complete.
Note: The television is now in HOTEL Mode.
4. Disconnect the clone box from the television and
turn it OFF.
Note: Data is not lost even if the battery is
removed.
Downloading Settings into Other Televisions (TEACH)1. Press the POWER ON button on the clone box.
• The LEDs will flash red and green to confirm
power is ON.
2. Connect the clone box to the Digital Interface port
on the back of the television.
• The television must be plugged into an AC
outlet but can be either OFF or ON.
3. Press the TEACH button.
• The green LED will flash while data is
downloaded to the television. The green LED
will light for about two (2) seconds when the
procedure is complete.
Note: The television is now in HOTEL Mode.
4. Disconnect the clone box from the television and
turn it OFF.
5. Repeat steps 1– 4 to set up other televisions.