Cord routing (example)

ORoute the camera cord so that it does not allow rainwater etc. to penetrate.

OAllow enough slack in the cord so that it is not pulled when the door is opened and closed.

Hatchback or Van type

Cord clamp

Harness cover

Tie band

Tie to the harness cover.

Route the cord above the back door (outside).

Fasten with cord clamps at key points, then bring the cord in where the clearance from the edge of the door is wider.

Do not route the cord under the back door (inside).

The cord will be damaged if pinched by the edge of the back door.

Car navigation etc.

Rear view camera

Rear view camera control unit

Cord rail

(peel off backing paper) Cut to the appropriate size.

Rear view camera cord

Rubber water seal (Attached to rear view camera.)

Place against the rubber gasket and bring the cord into the interior.

Cord clamp

Page 12
Image 12
Panasonic CY-RC50KU operating instructions Cord routing example, Hatchback or Van type