Panasonic DMCTS4K, DMCTS4D, DMCTS4A, DMC-TS4K owner manual 124, Ground Roof

GPS/Sensor

∫Example of adjusting the altitude manually

(measuring the height from the ground to the roof of a building)

1 Set [ON] in [Adjust] in [Altimeter] on the ground A, and then set the altimeter to 0 m (0 feet).

2Move from the ground A to the roof B.

3 Check the altitude measured on the roof B.

A Ground

BRoof

CHeight of building (relative altitude)

Note

• When [Adjust] is set to [GPS], the altitude prior to and after recording can vary according to the timing at which GPS data is received.

•Adjustment is not possible when the measured value exceeds the display range. It will display [----].

•With the displaying of the relative altitude, it may display with negative numbers even if it is higher than sea level depending on the value adjusted with [Adjust] in [Altimeter].

•After adjustment, errors of a few metres may still occur. For information on preserving the adjusted accuracy, read “About the measured altitude and atmospheric pressure” (P128).

- 124 -