30 VQT3V42
This unit does not recognize the USB
connection correctly.
¾Disconnect and reconnect the USB cable. If it
still does not recognize the connection, turn
this unit off and on again.
¾USB devices may not be recognized by this
unit when connected using the following :
– a USB hub
¾If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
The unit switches to standby mode.
¾This unit will automatically turn to standby
mode after 30 minutes if it is inactive. (>16)
¾One of the unit’s safety devices is activated
(U59 is displayed). Wait until this unit has
cooled down.
The images from this unit do not appear on
the television.
Picture is distorted.
¾An incorrect resolution is selected in “HDMI
Video Format”. Reset the setting as follows:
– “00rEt” is displayed on the unit’s display.
Set the item again. (>24)
Video is not output in high-definition.
¾Confirm that “HDMI Video Format” in the
Setup menu is set properly. (>24)
A black band is displayed around the edge of
the screen.
The aspect ratio of the screen is abnormal.
¾
Confirm the “TV Aspect” is set properly. (
>
27)
¾Adjust the aspect setting on the television.
– a USB extension cable other than the
supplied with the Wireless LAN Adaptor
DY-WL5 (optional)
Picture
1While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5seconds.
2Repeatedly press [1](right ) on the remote
control or [Í/I] on the unit until “04PrG” is
displayed on the unit’s display.
3Press and hold [OK] on the remote control or
[<OPEN/CLOSE] on the unit for at least
5seconds.
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output in
bitstream, select “Yes” in “Default Settings”
and make proper settings. (>28)
¾The unit and television are using different
video systems.
1While the unit is on, press and hold [OK], the
yellow button and the blue button on the
remote control at the same time for more than
5seconds.
– “00rEt” is displayed on the unit’s display.
2Repeatedly press [1](right ) on the remote
control or [Í/I] on the unit until “05Pln” is
displayed on the unit’s display.
3Press and hold [OK] on the remote control or
[<OPEN/CLOSE] on the unit for at least
5seconds.
The system switches from PAL to
NTSC
or
vice versa.
¾The system used on the disc doesn’t match
your television.
– PAL discs cannot be correctly viewed on an
NTSC television.
– This unit can convert NTSC signals to
PAL60 for viewing on a PAL television
(>24, “NTSC Contents Output”).
DMP-BD77GN-VQT3V42.book 30 ページ ２０１２年２月２１日　火曜日　午前１０時５分