Course | Time required (guide) |
Follow the steps outlined below if the status lamp blinks or glows
English
1 Charge | Charge |
|
| |
0 to 60 min |
|
| ||
|
|
| ||
|
|
|
| |
2 Clean/Dry/ | Clean | Dry | Charge | |
80 min | ||||
Charge | 10 min | 0 to 60 min | ||
(170 min*) | ||||
|
|
|
•It is not possible to change the course after the “Clean/Dry/Charge” course has started.
Blinks
Correctly set the detergent cartridge and then restart a course.
If the status lamp goes out
Continue a course.
Glows
Remove the shaver from the self- cleaning recharger and then check that the [CLEAN] lamp has gone out. (Be careful as the blade may be hot or wet.) Check that the water tank is correctly attached, the water tank cap is securely closed and the self- cleaning recharger is placed horizontally.
3 Dry/Charge | Dry | Charge | |
180 min | 0 to 60 min | ||
|
• It is possible to change to the “Clean/Dry/ |
Charge” course even after the “Dry/Charge” |
course has started. |
* When the ambient temperature of the |
low (approx. 15 °C (59 °F) or lower), the time it takes to dry the |
shaver increases. |
• The Clean or Dry function may stop under extreme low |
temperatures (approx. 0 °C (32 °F) or lower). In such a case, the |
When an abnormality has been corrected
Remove the AC adaptor from a household outlet.
When no abnormality was found
It is time to replace the detergent cartridge and cleaning liquid inside the water tank. Wash away the old cleaning liquid and then rinse the water tank and then refill it with water. Replace the old detergent cartridge and then restart the course.
CLEAN and DRY lamps will blink when the “Clean/Dry/Charge” |
course is selected, or the DRY lamp will blink when the “Dry/ |
Charge” course is selected. |
When the status lamp goes out
Continue a course.
When the status lamp glows again
Contact an authorized service center.
10
