Using Keyless drill chuck (EY9X003E)
CAUTION: • Use keyless drill chuck ONLY in Drill Driver Mode of EY6535.
This chuck is not designed to be used in IMPACT MODE.
It can be damaged and its life will be reduced. Moreover, the chuck
Top collar
Bottom collar
This Quick change chuck is designed to be used with Pana- sonic EY6535.
Top collar : To insert or to remove bit
Bottom collar : To attach or to detach Quick change chuck
and its metal parts, such as the push button, front parts, and bit may become very hot. To prevent skin burns, use work gloves and/or allow heated parts to cool down before handling.
•Make sure the work environment is safe. When retracting drill from work material, Keyless drill chuck may detach if subjected to 100kg or more of pull force. Detachment will be sudden. Use care and avoid excessive force when retracting drill from work material.
1.Attaching Keyless drill chuck (Fig. 2)
Attach the chuck by sliding the female detent on the bottom of the chuck to the square drive on the body.
Make sure the chuck is firmly connected to the body
2.Inserting the bit (Fig. 3)
Insert the bit, and turn the lock collar clock- wise(looking from the front) holding the sleeve until jaws close firmly.
3.Removing the bit (Fig. 4)
Turn the lock collar counterclockwise (looking from the front).
Then remove the bit.
CAUTION: If the drill bit becomes too tight to remove, hold two lock collars with pipe wrenches and turn them in opposite directions. (Fig. 5)
4. Detaching Keyless drill chuck (Fig. 6)
To detach the chuck, PUSH the button to release the chuck from the square drive.
CAUTION: Drill bit blade is sharp. Make sure to remove the drill bit before you set and detach the keyless drill chuck.
Using Quick change chuck (EY9HX110E)
Use 6.35 mm (1/4") hexagonal bits.
To ensure proper securement of the bit, use only hexagonal bits with 9.25 mm (3/8") detent. (Fig. 7)
CAUTION: Make sure the work environment is safe. When retracting bit from work material, Quick change chuck may detach if subjected to 50kg or more of pull force. Detachment will be sud- den. Use care and avoid excessive force when retracting bit from work material.
1.Attaching Quick change chuck
Attach the Quick change chuck by pulling the bottom collar forward and sliding the female detent on the bottom of the chuck to the square drive on the body.
Release the bottom collar to make sure the Quick change chuck is firmly connected to the body.
2.Inserting the bit (Fig. 8)
Pull the top collar of the Quick change chuck forward, then insert the bit.
Release the bottom collar to make sure the bit is firmly connected to the chuck.
3.Removing the bit (Fig. 9)
Pull the top collar of the Quick change chuck
forward, then pull the bit.
CAUTION: lmpact mechanism creates heat. Square drive and accessory may become very hot and may cause skin burns. To prevent skin burns, use work gloves and/or allow heated parts to cool down before handling.
4.Detaching Quick change chuck
Pull the bottom collar of the Quick change chuck forward to detach it.
Attaching or removing battery pack
1.To connect the battery pack:
Insert the battery pack. It snaps into place to indicate proper connection.
2.To remove the battery pack:
Press the two buttons on the sides of the bat- tery pack. Slide the battery pack out of the tool body.
— 8 —
