to be driven can be changed within the range of the screw count val- ues.
3.To prevent changes in the set values due to operational errors.
● Turn the HOLD switch |
|
to ON. | ON |
■While setting, if no operations are conducted for 60 or more seconds or when the battery is removed
●Operation for the set value be comes invalid.
Please reset the operational values.
■When batteries are changed while in use
●When batteries are changed, the count value is saved. Therefore, the drill can be used continuously.
Battery Low Warning Lamp
<Battery low warning lamp>
Off | Flashing |
(normal | (No charge) |
operation) | Battery |
| protection |
| feature active |
Excessive (complete) discharging of
●The battery protection feature acti- vates immediately before the bat- tery loses its charge, causing the battery low warning lamp to flash.
●If you notice the battery low warn- ing lamp flashing, charge the bat- tery pack immediately.
Clutch Lock Cover
The clutch lock cover allows you to lock the clutch at the selected setting.
Attaching the cover
1.Select the appropriate clutch set- ting for the application.
2.Attach the clutch lock cover.
●Align the triangle mark on the cover with the graduation selec- tion mark on the drill and attach.
Triangle mark | Graduation selection | |
|
| mark |
|
| |
|
|
|
|
|
|
|
|
|
Removing the cover
1.Grip the clutch lock cover with your fingers on the mark and the bot- tom of the cover, then push in and twist to remove.
●It will be difficult to remove the clutch lock cover from the drill if you push on the side of the cover while pulling it off.
Using the LED Light
Use the LED light on jobs in dark locations such as attics to illuminate your workspace.
CAUTION
●The LED light is intended for use as a supplemental light source. Do not use it as a flashlight.
Doing so may result in accident or injury.
●Do not look at the light or shine it directly into your eyes. Continuous exposure to the LED light may damage your eyes.
1.Press 
to toggle the light on and off.
●To use the light immediately after attaching the battery pack or after the drill has not been used for 5 minutes or more, operate the drill briefly.
- 10 -
