The light will automatically turn off if the drill is not used for 5 minutes.

The light uses an extremely small amount of current. Using the light has a negligible effect on the operational capacity of the drill.

The LED is incapable of lighting the tip of the bit when the drill is used in the straight configuration.

Bit-locking Function

With the switch at off and the bit lock­ ed in place, the tool can be used as a manual screw-driver - up to 14.7 N·m (150 kgf-cm, 130 in-lbs).

There will be a little play in the driving shaft, but this is not a malfunction.

Forward

Forward

Reverse

Reverse

Speed Selector Switch

To suit the application of this tool, two different rotational speeds are avail- able. Depending upon use, either the high or low speed should be select- ed.

HIGHLOW

 

Speed selection

Torque

LOW

200 min-1

(rpm)

High

HIGH

600 min-1

(rpm)

Low

CAUTION:

Check speed selector switch before use.

Do not operate the speed selector switch while the main switch is on (switch is in the ON position).

Main Switch Lock

After use, set the main switch lock at the lock position to prevent accidental operation.

Main switch lock

Lock

 

Main Switch (ON/OFF)

Push the upper half of the switch for forward rotation, or the lower half for reverse rotation.

Battery Pack (EY9L10)

CAUTION:

1.Remove the battery pack away from the tool.

2.Charge the battery pack using the battery charger.

- 11 -

Page 11
Image 11
Panasonic EY7411  Bit-locking Function,  Speed Selector Switch,  Main Switch Lock,  Main Switch ON/OFF