4)Be aware that this tool is always in an operating condition, since it does not have to be plugged into an elec- trical outlet.
5)If the bit becomes jammed, imme- diately turn the trigger switch off to prevent an overload which can damage the battery pack or mo- tor. Use reverse motion to loosen jammed bits.
6)Do not operate the Forward/Reverse lever when the trigger switch is on. The battery will discharge rapidly and damage to the unit may occur.
7)When storing or carrying the tool, set the Forward/Reverse lever to the center position (switch lock).
8)Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops. The protection cir- cuit will activate and may prevent speed control operation. If this hap- pens, release the speed control trigger and squeeze again for nor- mal operation.
9)Be careful not to get dust inside the chuck.
10)Do not touch the rotating parts to avoid injury.
11)Do not use the tool continuously for a long period of time. Stop using the tool from time to time to avoid temperature rise and heat overload of the motor.
12)Do not drop the tool.
13)Do not put the tool on the place where the chuck is depressed. The bit may come off from the chuck and fall down when the chuck is depressed. It may cause injuries.
Symbol | meaning | ||||||
|
| V | Volts | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Direct current |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| n0 | No load speed | ||||
|
|
|
|
|
|
|
|
… | Revolutions or | ||||||
|
|
|
|
|
|
| reciprocation per minutes |
|
|
|
|
|
|
| Rotation with hammering |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Rotation only |
|
|
|
|
|
|
|
|
WARNING:
Some dust created by power sand- ing, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of Cal- ifornia to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
*Lead from
*Crystalline silica from bricks and cement and other masonry prod- ucts
*Arsenic and chromium from chem-
To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter the microscopic particles.
.FOR BATTERY
CHARGER & BAT- TERY PACK
Important Safety Instructions
1)SAVE THESE INSTRUCTIONS
2)Before using battery charger, read all instructions and cautionary mark- ings on (1) battery charger, (2) bat- tery pack.
3)CAUTION - To reduce the risk of in- jury, charge only Panasonic Battery Pack as shown in last page.
Other types of batteries may burst causing personal injury and dam- age.
4)Do not expose charger to rain or snow.
5)To reduce the risk of damaging the electric plug and cord, pull by plug rather than cord when disconnect- ing charger.
6)Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
- 6 -
