. MAINTENANCE
Use only a dry, soft cloth for wiping the unit. Do not use a damp cloth, thinner, benzine, or other volatile solvents for cleaning.
. ACCESSORIES
CAUTION:
To prevent the risk of injury, only use accessory or attachment for its stated purpose.
Bit adapter (included) •EY9HX403E
Drill chuck (Optional accessory) •EY9HX400E
Use with wood drill bit or metal drill bit with shank of 1.5 mm to 13 mm diameter.
Do not use the drill chuck in “Rotation with hammering mode” ( 
). Use in "Rotation with hammering mode" may cause break of chuck or bit and result in injury.
Hammer chuck (Optional accessory) •EY9HX401E
Use with concrete drill bit, wood drill bit or metal drill bit with straight shank of 2.5 mm to 13 mm diameter.
Do not use the hammer chuck with wood drill bit or metal drill bit in “Rotation with hammering mode” ( 
). Use in “Rotation with hammering mode” may cause break of bit and result in injury.
If you need any assistance for more details regarding these accessories, ask your local service center.
. USAGE SUGGESTION
1.If there isn’t enough force pushing down on the bit, the tool may not be able to blow in hammering mode.
This is to prevent the hammering mode from operating with no load. Press down harder on the bit to engage the tool and cause it to blow.
Always be sure to press down with enough force when working.
2.In winter or in other situations where the temperature of the unit is low (5°C (41°F) or below), the blow of the hammering mode may be weaker than normal at the beginning stage.
This is because the grease becomes stiffer in low temperatures, increasing fric- tion.
If this should happen, operating hammering mode with no load for approximately 30 seconds and repeat this 3 times. This will restore its blowing power.
- 14 -
