Panasonic EY7840 Operation, Control Panel, Forward/Reverse Lever, Variable Speed Control Trigger

.OPERATION

Forward/Reverse Lever

ForwardReverse

Variable Speed Control Trigger

To set the center of a hole, pull the trigger slightly to start the drill rotation slowly.

The more the speed control trigger is pulled, the higher the speed becomes.

Control Panel

Lock

Be sure to set the lever in the center to lock it after use.

(1)

(3)

(2)

Operate the Forward/Reverse lever after the motor rotation is completely stopped.

Hammering/Drilling Switching Lever

NOTE: Operate the mode change after the motor rotation is completely stopped.

Position of	Action mode	Operation
switching lever

Rotation with Concrete hammering Drilling,

Block Drilling

Screw

Rotation only Fastening,

Drilling

Clutch Torque Setting

Adjust the torque to one of the 5 clutch settings or “ ” position.

CAUTION:

Test the setting before actual operation.

Set the scale at this mark ( ).

(1) LED light

Pressing toggles the LED light on and off.

The light illuminates with very low current, and it does not adversely af- fect the performance of the driver during use or its battery capacity.

CAUTION:

•The built-in LED light is designed to illuminate the small work area tem- porarily.

•Do not use it as a substitute for a regular flashlight, since it does not have enough brightness.

This product has the built-in LED light. This product is classified into “Class 1 LED Product” to IEC (EN) 60825-1:2001.

LED RADIATION

DO NOT STARE INTO BEAM

CLASS 1 LED PRODUCT

Use of controls or adjustments or perform- ance of procedures other than those speci- fied herein may result in hazardous radiation exposure.

- 9 -