LAMP INDICATIONS
|
|
|
|
|
|
|
|
|
|
| Charging is completed. (Full charge.) |
|
|
|
|
|
|
|
|
|
|
| Battery is approximately 80% charged. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Now charging. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Charger is plugged into the AC outlet. Ready to charge. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| (Green) | (Orange) | Charging Status Lamp. | ||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
| Left: green Right: orange will be displayed. | ||||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Battery pack is cool, or the voltage of the battery is low. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| The battery pack is being charged slowly to reduce the load on the battery. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Battery pack is warm. |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Charging will begin when temperature of battery pack drops. If |
|
|
|
|
|
|
|
|
|
|
| the temperature of the battery pack is |
|
|
|
|
|
|
|
|
|
|
| status lamp (orange) will also start flashing. Charging will begin |
|
|
|
|
|
|
|
|
|
|
| when the temperature of the battery pack goes up. |
|
|
|
|
|
|
|
|
|
|
| Charging is not possible. Clogged with dust or malfunction of |
|
|
|
|
|
|
|
|
|
|
| the battery pack. |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| Turn off | Lit | Flashing | ||
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful in- terference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
●●Reorient or relocate the receiving antenna.
●●Increase the separation between the equipment and receiver.
●●Connect the equipment into an outlet on a circuit different from that to which the re- ceiver is connected.
●●Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, install and use in accordance with provided instructions. Use only the battery pack specified in the instructions. Any changes or modifications not expressly approved by the party responsible for compli- ance could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian
- 13 -
