Panasonic EYFEA1N operating instructions Clutch Lock Cover, Battery Pack For Appropriate Use

• Clutch Lock Cover

The clutch lock cover allows you to lock the clutch at the selected setting.

Attaching the cover

1.Select the appropriate clutch setting for the application.

2.Attach the clutch lock cover.

•Align the triangle mark on the cover with the graduation selection mark on the drill and attach.

Triangle mark Graduation selection mark

Tightening the screw to immobilize the cover.

•Use a hand screwdriver. Tightening the screw too much may damage the cover.

Caution: DO NOT STARE INTO BEAM. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Automatic power-off function

●●The automatic power-off function is designed to prevent a loss of tightening torque due to reduced battery voltage. Once it has been activated, the tool will not operate until the battery pack has been charged (or replaced with a fresh unit), even if the trigger is depressed.

●●LED lamp will flash when the automatic power-off function is activated.

●●LED lamp begins flashing, the battery pack should be charged (or replaced with a fresh unit) immediately.

●●Be sure to fully charge the battery pack in question after activation of the automatic power-off function. Failure to do so may prevent the automatic power-off funtion from being properly deactivated.

*Only use the screw that comes with the clutch lock cover.

Removing the cover

1. Remove the clutch lock cover.

LED light

Pull the trigger. The light illuminates with very low current, and it does not adversely affect the performance of the tool during use or its battery capacity.

CAUTION:

●●The built-in LED light is designed to illuminate the small work area tempo- rarily.

●●Do not use it as a substitute for a regular flashlight, since it does not have enough brightness.

- 11 -

[Battery Pack]

For Appropriate Use of

Battery Pack

Li-ion Battery Pack

●●For optimum battery life, store the Li-ion bat- tery pack following use without charging it.

●●When charging the battery pack, confirm that the terminals on the battery charger are free of foreign substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign substances are found on the terminals.

The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. during operation.

●●When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a con- nection from one terminal to another.

Shorting the battery terminals together may cause sparks, burns or a fire.

●●When operating the battery pack, make sure the work place is well ventilated.

●●When the battery pack is removed from the main body of the tool, replace the battery pack cover immediately in order to prevent dust or dirt from contaminating the battery terminals and causing a short circuit.