Panasonic GP-KS1000E manual User File Setting

USER FILE SETTING

User preference stored can be accessed by selecting user switch.

1.Remove the switch cover on the rear of the camera control unit by removing the screw.

Screw

@6@8#0#2 @0 @5@7@9#1

ON

1 2 3 4 5 6 7 8

7	8	9A	7	8	9A
6		B	6		B
5		C	5		C
4			4
2		D	2		D
		E			E
3			3
10F			10F

@1 @2@3@4

2.Select a desired user file (1 - 4) by turning User Switch !0on the front panel.

3.Set User File Set On/Off Switch @5on the rear panel to ON.

4.Select an item for adjustment by turning User File Item Switch @2on the rear panel.

The item numbers and the corresponding items are shown below.

Item No.	Item	Adjust control @3Select switch @4
0	G/L H Phase	Valid	Invalid
			Valid 0:0°
1	G/L SC	Valid	1:90°
	Coarse/Phase		2:180°
			3:270°
2	DTL Level	Valid	Invalid
3	Chroma Gain	Valid	Invalid
4	Colour Matrix	Valid	Invalid
	(R-G)
5	Colour Matrix	Valid	Invalid
	(B-G)
6	Pedestal Level	Valid	Invalid
			0: ALL
	AGC/ELC		1: CENTRE
7		Invalid
			2: S CIRCLE
	Sensing Zone
			3: M CIRCLE
			4: L CIRCLE
8	(NC)
9	Reset All	Invalid	Invalid
	Settings

AGC/ELC Sensing Zone (Item No. 7)

0:ALL 1:CENTRE 2:S CIRCLE

3:M CIRCLE 4:L CIRCLE

Note: Item 1 and 2 settings are not stored at each user file distinctively.

5.Select or adjust the level of each item by the User File Select switch @4or User File Adjust control @3.

6.Press User File Set switch @1to store the adjusted value in the memory.

7.Repeat the above steps 4 to 6 set the other items.

8.After all the necessary items have been set, set Use File Set ON/OFF Switch @5to OFF.

9.Place the switch cover back on the switch panel on the rear of the camera control unit and fasten it with the screws.

Caution

Do not set User File Item switch @2to A through F positions.

If A to F is selected, use both User File Item switch @2 and User File Select switch @4to the position F, then press User File Set switch @1.

-10-