Panasonic HDC-SD1 operating instructions 110

Others

Problem

Check points

This unit cannot be	≥The unit cannot be operated if the LCD monitor is not opened.
operated though	≥Press the RESET button. (l 113) If normal conditions are not
powered up.	restored yet, remove the battery or AC adaptor, wait about 1 minute
This unit does not	and then reconnect the battery or AC adaptor. Then about 1 minute
	later, turn on the power again. (Conducting the above operation
operate normally.	while the card is being accessed may damage the data on the
	SD card.)
The remote control does	≥Has the button-type battery of the remote control run out?
not function.	# Replace it with a new button-type battery. (l 19)
The screen has changed	≥Has the demonstration started?
suddenly.	# If you set [DEMO MODE] to [ON] without inserting an SD card in
	recording mode, the demonstration automatically starts.
	Normally this should be set to [OFF]. Press the MENU button,
	then select [SETUP] # [DEMO MODE] # [OFF] and press the
	cursor button.
A function indication	≥If you set [SETUP] > [DISPLAY] > [OFF], indications other than
such as the remaining	warnings and date indications disappear.
time indication or the
elapsed time indication is
not shown.
Recording does not start	≥Has the SD card’s write protect switch been set to LOCK?
although power is	# No recording is possible while the write protect switch is set to
supplied to this unit and	LOCK. (l 21)
the SD card is correctly	≥Is the memory of the SD card full?
inserted.	# If there is no more available memory, free up some memory by
	deleting unnecessary scenes or use a new SD card. (l 28, 69,
	71)
	≥Is the unit set to recording mode?
	# No recording is possible if the mode dial is set to other than	.
	≥Is the card slot cover open?
	# If the card slot cover is open, this unit may not operate normally.
	Close the card slot cover.
The unit arbitrarily stops	≥Can the SD card be used for motion picture recording?
recording.	# Use an SD card that can be used for motion picture recording.
	(l 20)
	≥Is the AGS function activated?
	# Record in the normal horizontal position or set [AGS] to [OFF].
	(l 39)

110

VQT1A34