Panasonic HDC-SD1 operating instructions Connection and recognition procedures

With a computer

Connection and recognition

Connection and recognition procedures

After the software applications are installed, this unit must be connected to the computer and be correctly recognised by the computer.

≥Connect after installing the software applications.

≥Remove the supplied CD-ROM if it is inserted in the computer. (If the [Setup Menu] screen is displayed, wait until it finishes and then remove the CD-ROM.)

≥If the recognition procedure is not accomplished properly, operation will not be possible after connecting the unit to the computer.

≥If the unit fails to operate normally, it may mean that you have not conducted the installation or recognition procedure properly.

1Insert the battery and connect the AC adaptor.

≥If you do not insert the battery and connect the AC adaptor, operation will not be possible after connecting this unit to the computer.

2Insert an SD card with recorded images in this unit and then set the mode dial to PC to turn on the power.

3Connect this unit and a computer.

A

AUSB cable (supplied)

This unit is automatically recognised by the computer.

≥Insert the plugs as far as they will go. The unit and computer will not operate properly if the

plugs are not inserted fully.

≥Do not use any other USB connection cables except the supplied one. (Operation is not guaranteed with any other USB cables.)

≥When the unit is connected to a computer, the operation mode cannot be changed and its power cannot be turned off.

In this case, disconnect the USB cable (l 96). ≥When a computer is accessing the SD card in

this unit, the card access lamp lights. (When a

card is being accessed, appears on the LCD monitor.) Do not disconnect the USB cable or AC adaptor while the card is being accessed as it may damage the data.

≥It may be necessary to reboot the computer after connecting this unit to it for the first time.

94

VQT1A34