Before using

Using grip belt

Adjust the length of the grip belt so that it fits your hand, and hold it properly.

1Flip the belt.

2Put your hand through the grip belt.

ARubber grip

1 Loosen the belt.

2 Put your hand through the belt as far as it goes.

≥Slip your hand through the belt as far as it goes so that your fingers will grip the rubber area firmly.

3Replace the belt.

Lens hood

Rotate the lens hood counter-clockwise A to remove it. In order to attach it, place into slot B, and then rotate it clockwise C.

A

 

B

C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

≥Attach the MC protector or the ND filter of the Filter Kit (VW-LF43NE; optional) in front of the lens hood. Do not attach the other accessories on the hood. (Except for the lens cap)

(Refer to the operating instructions for the Filter Kit.)

(Be careful about the following.)

When 2 lens accessories, such as the ND filter, are attached and the W/T lever is pressed toward the W side, the 4 corners of an image will be darkened. (Vignetting)

≥Tighten up the belt so that your hand remains firmly in place.

16

VQT1A34

Page 16
Image 16
Panasonic HDC-SD1 Using grip belt, Flip the belt Put your hand through the grip belt, Be careful about the following