Panasonic HDC-TM41P/PC Troubleshooting, Power, Indication, Problem, Check points, turned on

Models: HDC-SD40P/PC

1 132
Download 132 pages 4.36 Kb
Page 103
Image 103
Troubleshooting

Others

Troubleshooting

 

Power

Problem

Check points

This unit cannot be

≥ Charge the battery again to ensure it is sufficiently

turned on.

charged. (l21)

This unit does not stay

≥ In cold places, the battery using time becomes shorter.

≥ The battery has a limited life. If the operating time is still

on long enough.

too short even after the battery is fully charged, the

 

Battery runs down

battery has worn out and needs to be replaced.

quickly.

 

 

 

This unit is turned off

≥ If the unit turns off when you turn off the power to the TV

automatically.

using the TV remote control, the VIERA Link is at work. If

 

you are not using the VIERA Link, set [VIERA Link] to

 

[OFF]. (l78)

 

 

This unit cannot be

≥ Remove the battery or AC adaptor, wait about 1 minute

operated though it is

and then reconnect the battery or AC adaptor. Then

turned on.

about 1 minute later, turn on the unit again. (Conducting

This unit does not

the above operation while the media is being accessed

may damage the data on the media.)

operate normally.

≥ If normal operation is still not restored, detach the power

 

 

connected, and contact consumer support. (l 124, 125)

 

 

“ERROR OCCURRED.

≥ The unit has automatically detected an error. Restart the

PLEASE TURN UNIT

unit by turning the unit off and on.

OFF, THEN TURN ON

≥ The unit will be turned off in about 1 minute if the unit is

AGAIN.” is displayed.

not turned off and on.

 

≥ Repair is needed if it is repeatedly displayed even if it is

 

restarted. Detach the power connected, contact

 

consumer support. (l124, 125) Do not attempt to repair

 

the unit by yourself.

 

 

 

Indication

Problem

Check points

Remaining battery

≥ The remaining battery capacity indication is an

indication is not

approximation.

displayed properly.

If the remaining battery capacity indication is not

 

displayed correctly, fully charge the battery, discharge it

 

and then charge it again.

 

 

The remaining time

≥ [DISPLAY] of the [SETUP] is [OFF]. (l 40)

indication or the elapsed

 

time indication is not

 

shown.

 

 

 

 

103

VQT3J95

Page 103
Image 103
Panasonic HDC-TM41P/PC Troubleshooting, Power, Indication, Problem, Check points, This unit cannot be, turned on, quickly