Panasonic HDC-SD40P/PC, HDC-TM41P/PC, HDC-TM40P/PC owner manual Quick Start, Alert Sound

[QUICK START] [OFF]/[ON]

This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.

≥When in Quick start standby mode about 60% of the power used in Recording pause mode is being consumed, so the recording time will be reduced.

≥

Quick start will not work if there is no SD card inserted.

≥ /

Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no SD card inserted.

≥Change the mode to .

1Set [QUICK START] to [ON].

2Close the LCD monitor while the mode is set to

.	
The status indicator A flashes green and the unit goes
into Quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit	
is put into recording pause.

≥Quick Start Standby Mode is canceled if jabout 5 minutes have elapsed

jmode is set to

≥It may take some time for Automatic white balance to adjust.

≥In the Quick Start Mode, the zoom magnification becomes 1k.

≥If [ECONOMY] (l41) is set to [5 MINUTES] and the unit automatically goes into Quick Start Standby Mode, close the LCD monitor and then open it again.

≥Turn the unit off using the power button.

[ALERT SOUND] [OFF]/ /

Starting and stopping of recording and unit on/off can be confirmed with this sound.

(Volume low)/ (Volume high)

2 Beeps for 4 times

When an error occurs. Check the sentence displayed on the screen. (l 101)

42

VQT3J95