Quick Guide

Inserting the battery

Install the battery by inserting it in the

Inserting/removing an SD card

direction shown in the figure.

 

AInsert the battery until it clicks and locks.

Charging the battery

BDC input terminal

1Connect the AC adaptor to the DC input terminal.

2Connect the AC cable to the AC

adaptor, then the AC outlet.

The status indicator will flash red at an interval of 2 seconds, indicating that charging has begun.

It will turn off when the charging is completed.

Access lamp [ACCESS] A

When this unit is accessing the SD card or built-in memory, the access lamp lights up.

Check that the access lamp has gone off.

1)Open the SD card cover and insert (remove) the SD card into (from) the card slot B.

Face the label side C in the direction shown in the illustration and press it straight in as far as it will go.

Press the center of the SD card and then

pull it straight out.

2)Securely close the SD card cover. ≥ Securely close it until it clicks.

12

VQT3J56

Page 12
Image 12
Panasonic HDC-TM90P/PC owner manual Quick Guide, Inserting the battery, Inserting/removing an SD card, Charging the battery