Initial Setup Mode
The 18 features (items) can be set in the Initial Setup
mode through the Control Panel. For the features and
the indicators condition, refer to Page 34. These
features can also be set through the Control Panel
Software program (Page 25).
1. Load a sheet of paper (Page 20), and turn the
power off.
2. While pressing
LOAD/PARK
, turn the
power on to enter the Initial Setup mode.
Both FONT indicators and the HIGH SPEED
indicator will be blinking. The current settings will be
printed automatically.
3. Press
FONT
and
ON LINE
to select the
item.
Each time you press
FONT
and
ON LINE
,
you will advance to the next item. Select an item and
confirm the selection with the FONT indicators (A)
and ON LINE indicator (B) (on, off, blinking)
(Page 34).
AB
4. Press
PITCH
to set the item’s status.
The item’s status will change each time you press
PITCH
(Page 34). To change additional
settings, repeat step 3 and 4.
5. Press
LOAD/PARK
to exit the Initial Setup
mode.
The FONT indicators will go off and the current
conditions will print.
Note
•To return all current settings to the factory
settings, follow the steps below.
1. While pressing
LOAD/PARK
, turn
the power on, then release.
2. Press
TEAR OFF
.
3. Press
LOAD/PARK
to exit the
Initial Setup mode.
Operating Instructions 33
Using the Control Panel