Battery Charge, Battery Life, Fully charged | Panasonic KX-TCD455E

455E.book Page 5 Thursday, March 20, 2003 7:44 PM

Setting up

Battery Charge

At the time of shipment, the batteries are not charged. To charge, place the handset on the base unit. Please charge the batteries for about 7 hours before initial use. During charging, the battery icon is as shown below.

Fully charged	During charging
(Flashing)
Display icon	Battery strength
	High
	Medium
	Low
	Needs to be
	charged

The handset which power is off will be turned on automatically when it is placed on the base unit.

In normal use, the handset and the base unit should be turned on at all times.

Battery Life

Battery life is dependent on use and conditions but in general when using fully charged Ni-MH batteries (700 mAh): Talk time: 10hrs approx.

Standby time: 120hrs approx.

When using Ni-Cd batteries (250 mAh): Talk time: 4hrs approx.

Standby time: 40hrs approx. (Times indicated are for peak performance)

The batteries reach peak performance after several full charge/discharge cycles. The batteries cannot be overcharged unless they are repeatedly removed and replaced.

If battery life is shortened then please check that battery and charge terminals are clean.

For maximum battery life, it is recommended that the handset not be recharged until the battery icon flashes

.

Preparation

Helpline Tel.No. :U.K. 08700 100 076 R.O.I. 01289 8333				5

Image 5

Panasonic KX-TCD455E operating instructions Battery Charge, Battery Life, Fully charged, Display icon

Contents

Operating Instructions Contents 08700 100 076 Monday Friday 900am 530pm Accessories includedBefore Initial Use Important Information Battery CautionEnvironment Location Connection Setting upBattery Installation Battery Life Battery ChargeFully charged Display icon Selecting the Battery Type Symbols Used in This Operating InstructionsReplacing the Batteries Please use only Panasonic P03PNi-MH or P03HNi-Cd batteries Handset Display Location of ControlsHandset Base unit Power On/Off Using the TelephoneSetting the Clock/Date Making a Call Answering a Call Receiver Volume/Speaker VolumeAuto Talk Temporary Bell Off Speakerphone Handset Locator/PagingTurning the Mic On/Off Phone Number Redialling Making CallsEditing the Dialled Number in the Redial List Clearing One/All Dialled Items in the Redial List Caller ID Display Caller ID ServiceCaller ID Editing a Received Number in the Caller List Caller ID ListCalling Back Phonebook Private Category FeatureStoring a Caller Information Name To enter Names/Characters in the phonebook To change the Character Mode To Search for a Name by Initial For example Felix Finding Items in the Phonebook Phonebook Character Table Number Editing Caller InformationClearing Caller Information Dialling with the Phonebook Pre-dialling Phone Number *1 Registering a Phone Number as a Hot Key Hot KeyDialling with a Hot Key Clearing Hot Key Registration To Copy an item/All items in the Phonebook Phonebook Copy To Send a Text Message from Fixed Line to Fixed Line SMS Feature Text MessagingTo Send a Text Message from Fixed Line to Mobile To Send a Text Message from Mobile to Fixed Line Phone Number *2 Writing and Sending New Messages Text Entry Selecting the Input Mode Reading/Displaying a Message in the Outgoing List Entering Text in LetterWise Mode Receiving a Text Message Sending/Editing/Clearing a Message from/in the Outgoing List SMS Messages Receive List .*2 Displaying/Reading a Message in the Incoming List Storing the Sender’s Phone Number in the Phonebook Before programming, please follow steps 1 toClear/Reply/Edit Incoming Messages Digit Base Unit PIN *1 Changing the SMS Service Centre NumberMessage Centre Number Digit LetterWise Character Table Buttons SMS Character TableSMS Character Table Time Alarm Handset SettingsSetting Alarm Time Setting Time Alarm On/Off Selecting the Ringer Pattern for Private Ring Setting the Ringer VolumeRinger Option Display Option Selecting the Standby Mode DisplayTone Option Call Option Setting the Direct Call On/Off Setting the Direct Call NumberOther Options Current 4-digit Handset PIN Key Lock Recall FeatureDialling Pause for PBX line/long distance service users 4-digit Base Unit PIN*1 5 Handset Number Base Unit Settings Time Break/Earth Recall Cancelling Call Restricted Number 4-digit Base Unit PIN*14 Base Unit 5 2 PIN *1 Pause Timing Reset Handset Initial SettingsHandset Initial Settings Function Digit Handset PIN*1 Digit Base Unit PIN*1 Reset Base Unit SettingsBase Unit Initial Settings Function Handset Registration to a Base Unit Multi-unit User Operation Digit Handset Number Cancelling a Base UnitCancelling a Handset Setting the Selected then All Handsets Mode Ringer Mode Selection Setting the All Handsets ModeSetting the Selected Handsets Mode Handset Numbers*2 Radio Cell Base Unit Selection Transferring a Call to Another Handset/Conference Call IntercomIntercom between Handsets Walkie-Talkie Set the Walkie-Talkie Mode Talking in Walkie-Talkie Mode To turn the Walkie-Talkie Mode ON/OFF Connecting the optional Headset Jack headset to the handset Using the Belt ClipOptional Headset Wall Mounting Before Requesting Help Problem Possible cause Solution 455E.book Page 50 Thursday, March 20, 2003 744 PM Error Code Description SMS-Text Messaging Problem Possible cause Solution Technical Information Specifications PIN Index Panasonic Business Systems U.K Guarantee 455E.book Page 55 Thursday, March 20, 2003 744 PM PQQX13447ZA D0303-0 For your future referenceSales Department Panasonic Business Systems U.K