Liquid damage Problem Cause/solution

TG1311_1312_1313BX(e).book Page 20 Tuesday, September 2, 2008 10:36 AM

Problem	Cause/solution
Caller information is not	L You must subscribe to a Caller ID
displayed.	service. Contact your service provider/
	telephone company for details.
	L If your unit is connected to any
	additional telephone equipment,
	remove and plug the unit directly into
	the wall jack.
	L If you use a DSL/ADSL service, we
	recommend connecting a DSL/ADSL
	filter between the base unit and the
	telephone line jack. Contact your DSL/
	ADSL provider for details.
	L Other telephone equipment may be
	interfering with this unit. Disconnect the
	other equipment and try again.
Caller information is slow	L Depending on your service provider/
to display.	telephone company, the unit may
	display the caller’s information at 2nd
	ring or later.
	L Move closer to the base unit.
I cannot remember the	L Change the PIN using the instructions
PIN.	on page 21.

Liquid damage

Problem	Cause/solution
Liquid or other form of	L Disconnect the AC adaptor and
moisture has entered the	telephone line cord from the base unit.
handset/base unit.	Remove the batteries from the handset
	and leave to dry for at least 3 days.
	After the handset/base unit are
	completely dry, reconnect the AC
	adaptor and telephone line cord. Insert
	the batteries and charge fully before
	use. If the unit does not work properly,
	contact your nearest Panasonic service
	centre.

Caution:

L To avoid permanent damage, do not use a microwave oven to speed up the drying process.

1{j/OK}

2{v}/{e}: “SETTING HS” i{>}

3{v}/{e}: “REGISTRATION” i{>}

4{v}/{e}: “REGISTER HS” i{>}

5Press and hold {x} on the base unit for about 5 seconds.

L If all registered handsets start ringing, press {x} to stop, then start again from step 1.

L The rest of the procedure must be completed within 4 minutes.

6{v}/{e}: Select a base unit number. i{>}

7Wait until “BS PIN” is displayed. iEnter the base unit PIN (default: “0000”). i{>}