Useful Information
Liquid damage
Problem | Cause/solution |
Liquid or other form of | L Disconnect the AC adaptor and |
moisture has entered the | telephone line cord from the base unit. |
handset/base unit. | Remove the batteries from the handset |
| and leave to dry for at least 3 days. |
| After the handset/base unit are |
| completely dry, reconnect the AC |
| adaptor and telephone line cord. Insert |
| the batteries and charge fully before |
| use. If the unit does not work properly, |
| contact your nearest Panasonic service |
| centre. |
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering the handset to the base unit
1{j/OK}
2{v}/{e}: “SETTING HS” i{>}
3{v}/{e}: “REGISTRATION” i{>}
4{v}/{e}: “REGISTER HS” i{>}
5Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6{v}/{e}: Select a base unit number. i{>}
7Wait until “BS PIN” is displayed. iEnter the base unit PIN (default: “0000”). i{>}
LIf you forget your PIN, contact your nearest Panasonic service centre. L When the handset has been registered successfully, w stops
flashing.
L If w is still flashing, start again from step 1.
Specifications
■Number of channels: 120 Duplex Channels
■Frequency range: 1.88 GHz to 1.90 GHz
■Duplex procedure:
TDMA (Time Division Multiple Access)
■Channel spacing: 1,728 kHz
■Bit rate: 1,152 kbit/s
■Modulation:
GFSK (Gaussian Frequency Shift Keying)
■RF transmission power:
Approx. 10 mW (average power per channel)
■Voice coding: ADPCM 32 kbit/s
■Power source:
■Power consumption: Base unit:
Standby: Approx. 1.2 W
Maximum: Approx. 3.9 W Charger*1:
Standby: Approx. 0.6 W
Maximum: Approx. 3.6 W
■Operating conditions:
5
22
