Panasonic KX-TG6724E Incoming call barring Caller ID subscribers only, Setting call restriction

Programming

“Yes” without entering any handset name,

“Handset 1” to “Handset 6” is displayed.

1#104

2Enter the desired name (max. 10 characters; page 42).

R If not required, go to step 3.

3

4MbN: Select the desired setting. a 2 times

5MN

Incoming call barring (Caller ID subscribers only)

This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls.

When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call.

Important:

RWhen the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list

(page 33) with after the call is disconnected.

Storing unwanted callers

You can store up to 30 phone numbers in the call barred list.

Important:

RYou must store the phone number with an area code in the call barred list.

nFrom the caller list:

1 MFN ()

2 MbN: Select the entry to be barred. a

3 MbN: “Caller Barred” a

4 MbN: “Yes” a a MN

nBy entering phone numbers:

1 #217 a

2Enter the phone number (24 digits

max.). a

R To erase a digit, press .

3MN

Viewing/editing/erasing bar call numbers

1#217

2MbN: Select the desired entry.

R To exit, press MN.

3To edit a number:

a Edit the phone number. a

a MN

To erase a number:

a MbN: “Yes” a a MN

Note:

RWhen editing, press the desired dial key to

add, to erase.

Setting call restriction

You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets are to be restricted. Storing area codes here prevents the restricted handsets from dialling any phone number in that area code.

1#256

2Enter the base unit PIN (default: “0000”). R If you forget your PIN, see page 46.

3Select the handsets to be restricted by pressing 1 to 6.

R All handsets registered to the base unit are displayed.

R “” is displayed next to the selected handset numbers.

R To cancel a selected handset, press the same dial key again. “” disappears.

4

5Select a memory location by pressing 1 to 6. a

30Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333

TG67xxE(en)_0802_ver102.pdf 30

2012/08/02 16:27:47