Changing the start and end time
Handset / Base unit
1MMENUN#237
2Continue from step 3 for handset or step
3 for base unit, “Turning silent mode on/
off”, page 32.
Changing the handset name
Each handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
Handset
1MMENUN#104
2Enter the desired name (max. 10
characters; see the character table,
page 22).
RIf not required, go to step 3.
3MSAVEN
4MbN: Select the desired setting. a
MSELECTN 2 times
5MOFFN
Call block (Caller ID subscribers
only)
This feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”,
page 33).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 34).
When a call is received, the unit rings for a
short time*1 while the caller is being identified.
If the phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
“Off” (page 34).
Important:
RWhen the unit receives a call from a
number that is stored in the call block list or
a call without a recognized phone number,
the call is logged in the caller list
(page 37) with after the call is
disconnected.
RYou can program this setting using either
the base unit or one of the handsets.
Storing unwanted callers
You can store up to 250 phone numbers in the
call block list.
Important:
RWe recommend storing 10 digits (including
an area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n From the caller list:
Handset
1MCN CID
2MbN: Select the entry to be blocked.
RTo edit the number: MMENUN a MbN:
“Edit” a MSELECTN
Press MEDITN repeatedly until the
phone number is shown in the 10-digit
format. And then, press MSAVEN. Go to
step 5.
3MMENUN
4MbN: “Save CID” a MSELECTN
5MbN: “Call block” a MSELECTN
6MbN: “Yes” a MSELECTN
7Edit the phone number if necessary (24
digits max.).
8MSAVEN a MOFFN
Base unit
1MCIDN
For assistance, please visit http://www.panasonic.com/help 33
Programming
TG684x7x(en)_1127_ver021.pdf 33 2012/11/27 18:16:47