Icon Feature
Time Settings
Caller List
Intercom
Initial Setup
Ringer Setup
Caller Barred
Screen saver modeThe backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing MN when on a call.
– pressing MeN at all other times.
Turning the power on/offPower on
Press MeN for about 1 second.
Power off
Press MeN for about 2 seconds.
Initial settingsn Direct command code:
Programmable settings can be accessed by
pressing MN (right soft key), #, and then
the corresponding code on the dial keypad
(page 21).
Example: Press MN (right soft key)
#101.
n Symbol meaning:
Example: MbN: “Off”
Press MCN or MDN to select the words in
quotations.
Display language
The display language is preset to French.
Sample displays shown in these operating
instructions are shown in English.
1MN (right soft key) #110
2MbN: Select your desired language. a
MOKN
3MeN
Date and time
Important:
RWhen you install the batteries for the first
time, the handset may prompt you to set
date and time. First press MOKN, then
proceed to step 2.
1MN (right soft key) #101
2Enter the current date, month, and year.
a MOKN
Example: 15 July, 2013
15 07 13
RYou can select the date format by
pressing #:
– dd/mm/yy (date/month/year)
– yy/mm/dd
3Enter the current hour and minute.
Example: 9:30
09 30
RYou can select 24-hour or 12-hour
clock format (“AM” or “PM”) by
pressing *.
4MOKN a MeN
Note:
RThe date and time may be incorrect after a
power failure. In this case, set the date and
time again.
Dialling mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1MN (right soft key) #120
13
Getting Started
TG7851TU(en-en)_0718_ver011.pdf 13 2013/07/18 11:59:59