Panasonic MC-CG901 operating instructions To Replace Belt, To Remove Belt

Motor Shaft

Arbre du moteur Eje del transmission del motor

Belt Guard

Protège-courroie

Protector de correa

Belt

Courroie

Correa

To Remove Belt

➢Remove worn belt.

➢Check and clean end cap areas. See AGITATOR ASSEMBLY for picture of complete agitator assembly.

To Replace Belt

➢Install new belt in belt groove on the agitator assembly, then over the motor shaft. Be sure belt is under the belt guard.

Front Support Tab

Languette de support à l’avant

Pestaña delantera del soporte

➢Insert both support tabs into the base slots. Then snap end caps into place.

Cover Slot

Fente du couvercle

Ranura de la cubierta

Front Base Tab

Languette à l’avant de la base

Pestaña delantera de la base

➢Line up tabs on front of base with slots inside the front cover.

Rear Base Tab

Languette à l’arrière de la base Pestaña posterior de la base

➢Tilt cover to back. Press cover firmly until rear tabs snap into place.

➢Turn POWER NOZZLE over. Replace the cover screws and lower the pile height adjustment rollers into place.

-44 -