Self Diagnostics Failure Code Explanation
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE | CAUSE | WHAT TO DO | |
F01 | • Overcooked food. | • Disconnect appliance from electricity supply to stop | |
|
| beep. | |
| • Temperature of exhaust air too high. | • Wait for appliance to cool down to reset operation. | |
|
| • If food ignites, do not open the door. | |
|
| • If normal operation does not resume, call the service | |
|
| agent with information of failure code. | |
|
|
| |
F05 | • Defective Memory IC. | • Disconnect appliance from electricity supply and wait | |
|
| more than 1 minute and reconnect. | |
• Defective thermistor circuit. | |||
• If normal operation does not resume, call the service | |||
|
| ||
F44 | • Defective control panel. | ||
agent with information of failure code. | |||
|
| ||
• Defective relay circuit. | |||
| |||
|
| ||
|
|
|
Note: Above codes shown in the display do not indicate all the possible failures on the unit.
Care of Your Microwave Oven
1.Disconnect the appliance from the electricity supply before cleaning.
2.Keep the inside of the oven clean. If pieces of food or spilled liquids stick to the oven walls, or between door seal and door surface, they will absorb microwave and may cause arcing or sparks. Wipe up all spills with a damp cloth. Kitchen detergent may be used if the oven gets very dirty. Do not use harsh detergents or abrasives.
3.The outside surface of this Microwave Oven should be cleaned with soap and water, then dried with a soft cloth. Make sure that water does not get into the back ventilation opening since this can damage the unit.
4.The window of the door should be washed with very mild soap and water. Be sure to use a soft cloth. Never use window cleaner. The door front can be scratched by harsh soap or detergents.
Cleaning the Air Filters
Clean the Air Filters occasionally according to the following instructions. Problems may occur with the oven if the filters become clogged with dirt or dust.*
1.Remove the right Air Filter from the front bottom skirt by pulling the Right Pop Pin straight out. Then slide the filter to the right and lift it off the post at the centre. Remove the left Air Filter the same as right one.
2.Wash the filters with soap and water.
3.To replace, align the filter with the centre post, and holding the front of the Pop Pin forward, locate the back of the pin into its hole. Press the front of the pin and it will pop into place. Be sure to replace the air filters before using this oven.
*If the Air Filter becomes clogged with dust or grease this will cause an overheat problem on the oven.
PROG
A 
A | B | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
|
|
|
|
|
|
| 8 |
| ProΙΙ |
| Post |
Pop Pin | Pop Pin |
- 17 -