Power Source Voltage Adjustment

The microwave oven Models NE-1757 and NE-2157 are factory set for 208 V operation. For 230 V - 240 V operation, the following adjustment MUST be made.

(Step 1) Make sure that the power cord is unplugged before removing the voltage adjustment panel cover.

(Step 2) Unscrew the voltage adjustment panel cover which is located on the back of the oven. Do not remove any other parts from the oven.

(Step 3) Remove the white connector and plug the black connector into the socket.

(Step 4) Store the unused white connector in the rectangular opening.

(Step 5) Reattach the voltage adjustment panel cover to the cabinet.

For 230 V - 240 V – Use black connector plug.

For 208 V – Use white connector plug.

To go from 230 V - 240 V to 208 V circuit follow steps

1-5 above, except at step 3, plug the white connector plug into the socket and store the black plug in the rectangular opening.

VOLTAGE ADJUSTMENT

CONNECTOR

VOLTAGE

ADJUSTMENT

PANEL

COVER

SCREW

How Does The Microwave Work?

Microwaves are a form of high frequency radio waves similar to those used by a radio including AM, FM, and CB. They are, however, much shorter than radio waves; approximately five inches long. Electricity is converted into microwave energy by the magnetron tube. From the magnetron tube, microwave energy is transmitted to the oven cavity where it is: reflected, transmitted and absorbed.

Reflection

Microwave are reflected by metal just as a ball is bounced off a wall. A combination of stationary (interior walls) and rotating antenna, located underneath the bottom shelf and above the ceiling cover assure that the microwaves are well distributed within the oven cavity to produce even heating or cooking of foods.

Transmission

Microwave pass through some materials such as paper, glass and plastic much like sunlight shining through a window. Because these substances do not absorb or reflect the microwave energy, they are ideal materials for microwave oven heating containers when covered.

Absorption

During heating, microwaves will be absorbed by food. They penetrate to a depth of about 34 to 112 inches. Microwave energy excites the molecules in the food (especially water, fat and sugar molecules), and causes them to vibrate at a rate of 2,450,000,000 times per second. This vibration causes friction, and heat is produced just as you will feel heat produced if you vigorously rub your hands together. The internal heating of larger foods is done by conduction. The heat which is produced by friction is conducted to the center of the food. Foods also continue to heat by conduction during standing time. (“carry-over” cooking)

Because microwave dissipate, much like sunlight as it reaches the Earth’s surface, they are not stored in food.

Radio Inference

1.Operation of the microwave oven may cause interference to your radio, TV or similar equipment.

2.When there is interference, it may be reduced or eliminated by taking the following measures:

a.Clean door and sealing surfaces of the oven. (See Care of Your Microwave Oven found on page 16.)

b.Place the radio, TV, etc. away from the microwave oven as far as possible.

c.Use a properly installed antenna, to obtain stronger signal reception.

- 5 -

Page 5
Image 5
Panasonic NE-1757R, NE-2157R, NE-1257R, NE-1258R manual Power Source Voltage Adjustment, How Does The Microwave Work?