27
Remarks, etc.
Basic Operations
3
Press the [1] Button
to start playback.
≥The [!] Indication 2
appears.
≥When the tape reaches
the end, it automatically
rewinds to the
beginning.
4
To stop playback:
Press the [∫] Button.
≥Never disconnect the
AC Adaptor during
Playback. This could
damage the Movie
Camera or the tape.
∫Adjusting the Sound Volume
(NV-VZ14/VZ15 only)
Push the [sVOLr] Lever toward [r] to increase the volume or
push it toward [s] to decrease the volume. The [VOLUME]
Indication appears and the number of bars increases or
decreases. When you release the Lever, this indication
disappears.
You can also adjust the volume with the °Remote Controller.
Increase the volume by pressing the [T] Button, or decrease it by
pressing the [W] Button.
This adjustment is only possible during playback.
°Remote Controller: NV-VZ15 only
≥Because the speaker contains a magnet, do not bring a
cassette near the speaker 3. It could adversely influence the
recorded content.
s
VOL
r
WT
VOLUME
BLC
1
!TBC
2∫
∫ TBC (Time Base Corrector) Function
Playback of certain cassettes can cause slight
horizontal shaking of the picture or other distortion.
To minimize such distortion and ensure a stable
playback picture, this Movie Camera is equipped with
the TBC Function. This function is automatically
activated within a few seconds after playback has
started, and the [TBC] Indication appears.
∫ Cancelling the TBC Function
With certain cassettes, however, the TBC Function
could cause slight vertical shaking or other distortion
in the playback picture. In this case, first try to adjust
the tracking (p. 28). If this does not improve the
picture, cancel the TBC Function by keeping the
[TBC] Button pressed until the [TBC] Indication
disappears. If you want to turn the TBC Function on
again, press the [TBC] Button for a few seconds until
the [TBC] Indication reappears. Even if you cancel
the TBC Function, it is automatically turned back on
when you switch the Movie Camera from the Camera
Mode to the VCR Mode.
∫ In the Following Cases, the TBC Function
Does Not Work:
≥In the Cue, Review or Still Playback Mode
≥When using the Camera Search or Recording
Check Function
≥When adjusting the tracking
≥When playing back an unrecorded part on the tape
When you play back a cassette with stretched,
shrunk or otherwise damaged tape, the TBC
Function does not work correctly (it may repeatedly
turn on and off). In this case, cancel the TBC
Function.