| Wireless remote controller |
Problem | Check points |
Cannot operate. | ≥ Check if the status display lamp is lit green and the unit is |
| turned on. |
| ≥ Before operating, select the unit by pressing one of the |
| CAM1 to CAM4 buttons. |
| ≥ When strong light from a fluorescent lamp, a plasma |
| monitor, the sun, etc. is shining on the wireless remote |
| control signal |
| respond. |
| ≥ If the status display lamp does not blink even when you |
| operate near the wireless remote control signal light- |
| sensing area, the batteries of the wireless remote |
| controller are depleted. Replace the batteries. |
| ≥ Set [IR Control] to [On] on the web setting screen. (l 36) |
|
|
| Controller |
Problem | Check points |
Cannot operate. | ≥ Check whether the status display lamp lights up green |
| and the unit is turned on. |
| ≥ Before operations, press CAMERA STATUS/ |
| SELECTION button 1 to 5 to select the camera. |
| ≥ It may be necessary to upgrade the version of the |
| controller so that the controller will support the unit. |
| Consult with your dealer. |
|
|
| Web setting screen |
Problem | Check points |
The web setting screen | ≥ Check the system requirements of the web setting |
cannot be accessed. | screen. |
| ≥ Use a category 5 or above LAN cable. |
| ≥ When the LAN lamp is not lit, the LAN is not connected |
| correctly or the connected network is not operating |
| correctly. Check for a loose contact of the LAN cable and |
| check the wiring. |
|
|
- 46 -