Garland BH/IN 2500 TROUBLESHOOTING continued, Malfunction With Error Code, Number of Flashing

TROUBLESHOOTING continued

Malfunction With Error Code

Number of Flashing	Possible Cause	Action To Take By Operator Or Operating
Signals (Code)		Personnel
E03	Overheated heat sink	Let unit cool down
- . . . - . . .		Check air filter and air flow
	Air-cooling system obstructed	Verify that air inlet and air outlet are not
		obstructed with objects
		Clean air filter
E04	Overheated cooking zone	Let unit cool down
- . . . . - . . . .		Check air filter and air flow
E06	Overheated electronic	Let unit cool down
- . . . . . . -		Check air filter and air flow
	Ambient temperature too high (the cooling	Verify that no hot air is sucked in by the fan.
	system is not able to keep the cooker in normal	Reduce the ambient temperature. The air inlet
	operating conditions 1)	temperature must be lower than 104°F/40°C
E07	Empty cooking sensing element activated	Reset empty cooking protection by switching
- . . . . . . . -		the unit off
E08	Ambient temperature beyond operating range	Make sure that the operating conditions
- . . . . . . . . -		(especially the ambient temperature) are kept
	Error on sensing element	Contact service agent

Order of error message: The indicator lamp lights up for an interval of 0.6 sec. The number of the following short flashes has to be counted and informs about the kind of error corresponding to the above mentioned code system.

The code will repeat until the error is cancelled.

1The cooling-system (fan) starts to operate when the ambient temperature in the control area exceeds 131°F/55°C. At heat temperatures higher than 158°F /70°C the controller automatically reduces the power to keep the unit in normal operating conditions. The cooker runs in a non continuous mode. This mode can be heard.

Part # 4520898 (03/31/11) Page 23