Garland SH/IN 5000 Fresh Air Intake Installation, Figure # 2 - Air Intake Housing, Silicone

INSTALLATION continued

Figure # 1

Cut Out Opening

Silicone

	Louvered
	Air Exhaust
	Opening
	(By Installer)
Sleeve with hose clip:	Aluminum air duct
mounted on bottom of unit
Sleeve with hose clip:	(Max 96" (8'))
	mounted on collars
mounted to cabinet	with hose clamps
	Removable grease -lter and air
	intake housing mounted on
Air Intake Housing	cabinet
See Fig. # 2	Fresh Air Supply

Fresh Air Intake Installation

The built-in induction units require a cooling air intake to operate effectively. The air intake housing is mounted to the cabinet, and is fitted with a removable stainless steel grease filter that can be cleaned in a dishwasher. Install the air intake housing and connect it to the induction unit with the aluminum air duct. Maximum length of this air inlet is to be 96” (8’). Make sure the cabinet is also equipped with a louvered air exhaust having a size of no less than 30 sq inches (50 sq inches for dual units) for the hot air to escape (by installer). Failure to provide adequate ventilation for the unit will result in the unit overheating, nuisance shut down and potential failure of the unit. (See Figures # 1 & 2)

Figure # 2 - Air Intake Housing

TOP VIEW

11" [279.4mm]

10 3/16" [258.8mm]

83/16" [208 mm]

9"

[288.6 mm]

5/32"

[4mm]

4 Holes

FRONT VIEW

See Cut out for air intake housing on next page

Part # 4520898 (03/31/11) Page 13