Projecting an image
Selecting the input signal
1. Switch on the connected devices.
Press the play button of the required device.
2.Press the INPUT SELECT button to select the required input method if needed. See “Switching the input signal” on page 26.
The image will be projected on the screen.
Positioning the image
1.Press the ASPECT button to select the required aspect mode. See “Switching the aspect ratio” on page 23.
2.Adjust the projected image with the lens shift levers. See “Lens shift and positioning” on page 16.
3. Adjust the angle of the projector.
Screw down the front leg adjusters and adjust the angle vertically.
See “Front leg adjusters and throwing angle” on page 15.
NOTE:
•AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See “AUTO SEARCH” on page 38.
4.Adjust the focus and the projected image size.
Turn the focus ring and zoom ring to adjust.
You can confirm the result with TEST PATTERN. See “TEST PATTERN” on page 39.
Focus ring
Zoom ring
NOTE:
•Do not touch the air exhaust port as this may cause burns or injury.
•If keystone distortion occurs, see “KEYSTONE” on page 36.
•If you adjust the focus, you may need to adjust the size of the image again.
