Read this first
Minimum required setting screen
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
LANGUAGE
Select the required language setting.
Preparation | LANGUAGE |
| |
| SELECT |
| ENTER |
Press F G I H buttons of the Remote control or Control panel on the projector to highlight the required language, and press ENTER to proceed to the next setting.
OPTIONS
Select the current projection method and fan speed setting. If you need return to the previous setting, press the RETURTN button.
OPTION
INSTALLATION | FRONT/DESK |
HIGHLAND | OFF |
| RETURN |
SELECT |
|
| ENTER |
INSTALLATION
Press I H buttons of the Remote control or Control panel on the projector to select the required installation method. Press G to proceed to the HIGHLAND setting.
FRONT/DESK | Setting on a desk/floor and | |
projecting from front | ||
| ||
FRONT/CEILING | Mounting in the ceiling and | |
projecting from front | ||
| ||
REAR/DESK | Setting on a desk/floor and | |
projecting from rear | ||
| ||
REAR/CEILING | Mounting in the ceiling and | |
projecting from rear | ||
|
HIGHLAND
If you use the projector at high elevation, the HIGHLAND setting need to be ON to set the fan speed high. Press I H to select the required option. If you need to return to the INSTALLATION, press F.
OFF | The fan speed is low. |
ON | The fan speed is high. |
NOTE:
•At 1 400 m (4 593 ft) above sea level, the setting must be ON.
•The loudness of fan noise depends on the HIGHLAND setting.
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is initialised. See “INITIALIZE ALL” on page 38.
You can change the settings from the MAIN MENU. See “Menu Navigation” on page 29.
