POSITION menu
Remote control | Control panel |
See “Navigating through the MENU” on page 29. See “Main menu and
DOT CLOCK
If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing I H to adjust the clock frequency.
Settings
KEYSTONE
If the projector is aligned
Image | Operation | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Setting range: -32 to +32
NOTE:
•You can correct the distortion ± 30 degrees from the plane. For a better quality image, installing the projector with a minimum of distortion is recommended.
•Some distortion may be retained for lens shift adjustment.
•The distortion of the Main menu screen is not correctable.
•The result of the keystone correction will affect the aspect ratio and the size of the image.
POSITION
You can move the projected image for fine adjustment. Press I H to move horizontally and F G vertically.
POSITION | H |
| V |
NOTE:
•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference.
•DOT CLOCK needs to be adjusted before adjusting the
CLOCK PHASE.
CLOCK PHASE
If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust.
NOTE:
•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference.
•CLOCK PHASE is available with PC signals and the following COMPONENT connection.
ASPECT
You can switch the aspect ratio manually when needed. Press I H to cycle through the options.
4:3 |
|
|
|
|
|
|
|
|
| AUTO | ||
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
16:9 |
|
|
|
|
|
|
|
|
| S4:3 | ||
|
|
|
|
| ||||||||
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
4:3
The input signal will be projected without any change.
