39
Basic Operation
38
Select the item pressing the For G
buttons on the remote control unit or
the projector.
Press the Ior Hbuttons, to adjust
the alternative items. For the
numerically adjustable items, press
the ENTER button to display an
individual screen, and press the I
or Hbuttons to adjust the setting.
Some items can be adjusted
pressing the For Gbuttons.
Adjusting the position
When the input signal is RGB, first
press the AUTO SETUP button to
initiate automatic positioning.
If the optimum setting is not
obtained when AUTO SETUP is
carried out, adjust by the following
procedure.
POSITION
POSITION
DOT CLOCK
CLOCK PHASE
KEYSTONE
OSD POSITION
RESIZING
AUTO SETUP
FRAME LOCK
STANDARD
H: 128 V: 32
H: 0 V: 0
32
16
OFF
OFF
ON
ON
TOP LEFT
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When an RGB/DVI signal is being
input
“POSITION”, “DOT CLOCK” and
“CLOCK PHASE” are not displayed
when a DVI signal is being input.
POSITION
POSITION
KEYSTONE
OSD POSITION
ASPECT
RESIZING
AUTO SETUP
STANDARD
H: 32 V: 16
H: 0 V: 0
OFF ON
TOP LEFT
AUTO
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When an S-VIDEO/VIDEO signal is
being input
POSITION
POSITION
KEYSTONE
OSD POSITION
ASPECT
RESIZING
AUTO SETUP
STANDARD
H: 32 V: 32
H: 0 V: 0
OFF ON
TOP LEFT
4:3
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When a YPBPRsignal is being input.
POSITION
KEYSTONE
OSD POSITION
AUTO SETUP
STANDARD
H: 0 V: 0
TOP LEFT
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When the NETWORK/SD CARD is
selected (PT-L780NTU only)

WHITE BALANCE R/G/B

(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised. Press the Ibutton to
make the selected color lighter.
Press the Hbutton to make the
selected color stronger.

Projecting sRGB-

compatible pictures

sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictures to be
reproduced more faithfully, make
the following settings.
#Press the FF or GG button to
select “PICTURE MODE”, and
then use the II or HH button to
select “NATURAL”.
$Press the FF or GG button to
select “COLOR TEMP.”, and
then use the II or HH button to
select “STANDARD”.
%Select the STANDARD from the
menu screen by pressing the
FFor GGbuttons and then press
the ENTER button.
&Select the LAMP POWER item
in the OPTION menu by
pressing the FFor GGbuttons
and set to “HIGH” by pressing
the IIor HHbuttons. (pages 44
and 45)
NOTE:
BsRGB is only enabled when RGB
signals are being input .