50-ENGLISH
LAMP POWER
This setting changes the lamp
brightness. When set to “ECO-
MODE”, the luminance of the lamp
is reduced, but the projector uses
less power, and the operating noise
is also reduced. This can help to
extend the lamp’s operating life. If
using the projector in small rooms
where high luminance is not
required, it is recommended that
you set the “LAMP POWER” to
“ECO-MODE”.
LAMP RUNTIME
This setting displays the usage time
for the lamp unit which is currently
being used. When replacing the
lamp unit, follow the instructions on
page 61, and reset “LAMP
RUNTIME” to “0”.
POINTER SELECT
If you press the POINTER button on
the remote control unit, the pointer
will be displayed. You can select the
pointer from 3 types as shown
below (refer to page 35).
A double circle will be
displayed.
A circle with a cross will be
displayed.
A hand will be displayed.
PC2 SELECT
This setting is used to select the
function of the PC 2 IN/PC 1 OUT
connector. When set to “INPUT”, it
is set to the PC 2 IN connector.
When set to “OUTPUT”, it is set to
the PC 1 OUT connector.
NOTE:
B“LAMP POWER” cannot be set
when no signal is being input.
NOTE:
BThe lamp’s operating life varies
depending on the usage
conditions (such as the “LAMP
POWER” setting and the
number of times the power is
turned on and off).