'Install the lamp unit cover, and then use a Phillips screwdriver to securely tighten the lamp unit cover fixing screws.
NOTE:
BBe sure to install the lamp unit and the lamp unit cover securely. If they are not securely installed, it may cause the protection circuit to operate so that the power cannot be turned on.
(Connect the mains lead.
)Press the POWER button so that a picture is projected onto the screen.
NOTE:
BIf “DIRECT POWER ON” in the “OPTION” menu has been set to “ON”, projection will start after the mains lead is connected. Refer to page 51 for details.
*Press the MENU button to display the menu screen, and then press the F or G button to select the “OPTION” menu.
+Press the ENTER button, and then press the F or G button to select “LAMP RUNTIME”.
,Press and hold the ENTER button for approximately 3 seconds.
The “LAMP RUNTIME” screen will be displayed.
NOTE:
BPress any button other than the POWER button to cancel the “LAMP RUNTIME” screen.
-Press the POWER button to turn off the power.
.Disconnect the mains lead after the POWER button on the projector illuminates red.
This will reset the cumulative usage time for the lamp unit to “0”.
