Panasonic PT-LB60NTE manual Lamp indicator

	LAMP indicator
Indicator	Illuminated (red)	Flashing (red)
display
	It is nearly time to	An abnormality has been detected in the lamp
Problem	replace the lamp	circuit.
	unit.
	B Does “REPLACE	B The power may	B There may be an
Possible	LAMP” appear on	have been turned	abnormality in the
	the screen after	on straight away	lamp circuit.
cause
	the projector is	after it was turned	B The lamp unit may
	turned on?	off.	be blown.
	B This occurs when	B Wait for a while	B Disconnect the
	the operation time	until the lamp unit	mains lead by
	for the lamp unit is	cools down before	following the
	nearing 1 800	turning the power	procedure on
	hours (when	back on again.	page 28, and then
	“LAMP POWER”		contact an
	has been set to		Authorised
Remedy	“STANDARD” and		Service Centre.
	when “AI” has		B Ask your dealer or
	been set to		an Authorised
	“OFF”). Ask your		Service Centre to
	dealer or an		replace the lamp
	Authorised		unit. (page 60)
	Service Centre to
	replace the lamp
	unit. (page 60)

NOTE:

BBe sure to disconnect the mains lead by following the procedure given in “Turning off the power” on page 28 before carrying out any of the procedures in the “Remedy” column.

BIf the TEMP indicator is illuminated and the power turns off after the procedures in the “Remedy” column have been carried out, it means an abnormality has occurred. Please contact an Authorised Service Centre so that the necessary repairs can be made.

58-ENGLISH