Panasonic PV-DV402 operating instructions Editing Features

External Microphone with M3 connector (not supplied)

Editing Features

Audio Dubbing using the External (PV-DV402 only) or Built-in Microphone

The original sound can be replaced with new sound using the built-in Palmcorder microphone or an external microphone (PV-DV402 only).

External Microphone Jack (PV-DV402 only)

Built-in Microphone

3JOG KEY

3MENU

1POWER

2PLAY

2PAUSE

3A.DUB

Before you begin

•Connect the external Microphone (if used) (PV-DV402 only).

•Turn on the Palmcorder.

•Insert a pre-recorded tape to be dubbed.

The AUDIO-REC setting in CAMERA MENU mode should be as follows:

	The original sound is recorded
12 bit	on ST (Stereo) 1, and the new
	sound will be recorded on ST
	(Stereo) 2.
16 bit	The original sound is replaced
	with the new sound.

•Select 12 bit if you do not want the original sound to be completely replaced during an audio dub.

•If you dub over a tape which has both

12 bit and 16 bit audio recordings on it, keep in mind that the original 16 bit audio portion will be completely replaced.

1 Set POWER to VCR.

•With the Remote Control, you can set the Palmcorder to stop automatically at a specified point on the tape. See “Memory-Stop Editing” on page 45.

2 Press (PLAY). Then press

(PAUSE) where you want dubbing to begin.

When using the Palmcorder only

3 Press MENU to display the VCR mode menu screen.

Rotate JOG KEY to select REC MODE , then press JOG KEY to display the VCR REC MODE menu screen.

Rotate JOG KEY to select AUDIO- DUB , and then press JOG KEY to select ON.

•The Palmcorder will go to Stand By mode, and “A.DUB” flashes in the EVF or the LCD monitor. Go to step 4.

When using the Remote Control only

3 Press A.DUB on the Remote Control.

•The Palmcorder will go to Stand By mode, and “A.DUB” flashes in the EVF or the LCD monitor. Go to step 4.

44
	Forassistance, pleasecall: 1-800-211-PANA(7262)orsende-mailto:consumerproducts@panasonic.com