Panasonic PV-DV52 operating instructions Photovu Link Driver Optional, Connection

PC Connection

PHOTOVU LINK Driver (Optional)

An image recorded on the DV Tape can be transferred to your PC (Personal Computer).

System Requirements for PHOTOVU LINK Driver (Optional)

• IBM PC/AT or compatible	recommended)
• Intel® Pentium® Processor
	• 3.5 inch 1.44 MB floppy disk drive
• Microsoft Windows 95/98/Me/NT4.0/
	(for installation)
2000/XP
	• RS-232C serial port (D-Sub 9-pin)
• RAM: 16 MB or more
	An adaptor (D-Sub 9-pin male to a
• 2 MB minimum available hard disk
	D-Sub female) is required for a
space
	D-Sub 25-pin
• 256 color monitor (full color
	• Mouse or other pointing device

*Satisfy the conditions recommended by Microsoft for Windows.

4

To PC Connector

2

RS-232C Serial port (D-Sub 9-pin) (Default is COM1.)

PC Connecting Cable for Windows (optional: PC Connection Unit (PV-DRS2, p 46))

PC

Connection

1 Turn off your PC.

2 Connect the Palmcorder to your PC (Windows) using the PC connecting cable (optional: PC Connection Unit (PV-DRS2, p 46)).

•Before connecting the Palmcorder to the PC, make sure the PC power is off to insure that images are transferred properly.

3 Turn on your PC.

4 Set the Palmcorder POWER to VCR.

Note

•For extended periods of use, it is recommended to use the AC Adaptor as a power source.

•Refer to PC or Windows manual to identify which COM port is to be used for connection.

Connection

43