6, 7PAUSE
To listen to the desired audio sound, set the 12 bit AUDIO setting of the VCR mode MENU (Menu OSD: p. 61) as follows:
12 bit AUDIO:The following selections are available for 12 bit AUDIO dubbed recordings only (sound recorded in SP mode only).
ST 1 | Set this position to listen to the | |
original sound. | ||
| ||
ST 2 | Set this position to listen to the | |
audio dubbed sound. | ||
| ||
| Set this position to listen to both | |
MIX | the original sound and the audio | |
| dubbed sound. |
Note
•When a 16 bit recording is dubbed over, the original audio of the recording will be erased.
•When a 12 bit recording is dubbed over and played back, and MIX is selected as the AUDIO, both the original audio and the dubbed audio are played back.
•If you recorded in LP mode, you cannot use the A.DUB feature.
Editing Features
6 Press 
(PAUSE) to start Audio Dubbing. “A.DUB 
” indication appears.
•Connect the Palmcorder to the TV in order to monitor the sound.
(p. 32)
Only NTSC (National Television Standards Committee) recorded tapes can be audio dubbed. The following screen appears if the tape was not recorded in NTSC format.
7 Press 
(PAUSE) to stop Audio Dubbing.
• If the microphone used for dubbing gets too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position is in or was started in a blank section, you cannot use the
A.DUB feature.Editing Features
39
