Before using
Power supply | • Connecting to the AC outlet |
•Charging the battery
When this product is purchased, the battery is not charged. Charge the battery before using this product.
•Battery charging time.
•We recommend using Panasonic batteries.
(-xx-,-72-)
•If you use other batteries, we cannot guarantee the quality of this product.
•If the DC Cable is connected to the AC adaptor, then the battery will not get charged. Remove
the DC Cable from the AC adaptor.
1 Connect the AC Cable to the AC adaptor and the AC Jack.
2 Put the battery on the battery mount by
aligning the mark, and then securely plug it in.
• Charging lamp Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start.
When the battery temperature is excessively high or low, the [CHARGE] lamp flashes and the charging time will be longer than normal.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions.
1 Connect the AC Cable to the AC adaptor and the AC Jack.
2 Connect the DC Cable to the AC adaptor.
3 Connect the DC Cable to this product.
•The output plug of the AC Cable is not completely connected to the AC adaptor jack. As shown in O, there is a gap.
•Do not use the power cord for other equipment since the power cord is exclusively designed for this Camcorder. Do not use the
power cord from other equipment for this Camcorder.
•Attaching the battery
Push the battery against the battery holder and slide it until it clicks.
•Removing the battery
While sliding the [BATTERY] lever, slide the battery to remove it.
•Hold the battery with your hand so it does not fall.
•Before removing the battery, be sure to set the [OFF/ON] switch to [OFF].
14
LSQT1121
