|
| With | a PC |
|
|
| |
To disconnect USB cable safely | When the following operations | are performed, the | |||||
| only) |
| same results will occur as when the USB cable is | ||||
HH_i_i_i_i_HHHH_iH_iHH__HiHHHHHHHHHHHH_i_i_incorrectly | removed (above). | Therefore, it is | |||||
_HHHHHH_i_iH_HHHHHHHHi i iHHHWiHHHHHH | |||||||
If USB cable is disconnected while the computer | imperative | that the above operation is completed | |||||
is on, the error dialog box may appear. In such a | before | proceeding. |
| ||||
case click [OK] and close the dialog box. By |
| ||||||
• When | the | SD Card is removed. | |||||
following the steps below yeu can disconnect the | • When Camcerder power is turned OFF. | ||||||
|
|
| |||||
cable safely. | icon in task tray. |
|
|
|
| ||
1 Double | click the |
|
|
|
| ||
• Hardware disconnect dialog box appears.
2 Select [USB Mass Storage Device] and click
[Stop].
• When Mode Dial is turned to change modes.
3 Verify [Matshita DVC USB Device] is selected and click [OK].
• You can safely disconnect the cable.
Note on the driver name displayed
The driver name displayed will differ depending on your OS, operating environment and the mode of the Camcorder.
•Make sure Camcorder's Card Access Lamp is off and disconnect the cable. Also, the icon will not be displayed when in Tape Recording Mode or Tape Playback Mode.
CAUTION:
If you disconnect the USB cable while the Card Access Lamp is on, it may damage the Card data.
If the above operation is not performed correctly, when data is copied from the personal computer to an SD Card, the copied data may be damaged.
When using on a Macintosh
Drag the [NO_NAME] or [Untitled] disk icon to the [Trash], and then disconnect the USB cable.
If you no longer need the driver
(Uninstall) (PV-GS85only)
1 Select [start] (>> [Settings]) >>
[Control Panel], select the driver from [Add/ Remove Programs] to uninetall.
•Uninstalling steps may vary depending on the OS. Please refer to the user manual of your OS.
53
LSQT1121
