Panasonic PV-V4603S warranty MTS Broadcast, VHS Hi-Fi Stereo System, System MTS, Connection

MTS Broadcast

Connection

Make the Audio/Video Connection as shown on page 3.

• You can use a TV connected to Stereo amp and speakers instead of a Stereo TV.

VHS Hi-Fi Stereo System

Audio Mode for Recording

1 Press SAP/ Hi-Fito display audio mode. (Display disappears after 5 seconds.)

• VHS Hi-Fi Stereo

R

L

VHF/UHF

TV

VCR

AUDIO OUT

R

L

R

Stereo Amplifier

AUDIO IN

2	Press SAP/ Hi-Fi repeatedly
	to select desired mode.
STEREO
SAP	• Refer to “Receivable
MONO
	Broadcast Types” on page 4.

• Arrow indicates selection.

3 Make a recording.

See p. 5 of “Basic Operations” Instruction book.

System • MTS

L

OUT TO TV

Receivable Broadcast Types

The following are possible audio broadcast types and on-screen displays.

The signal being received is indicated with an “ ” mark while the selected audio mode is indicated with an arrow.

To display the broadcast signal being received, ➛ press DISPLAY*.

MTS Stereo and SAP broadcast	STOP 12 : 0 0AM	CH 02
Multi-channel Television Sound Stereo (main language)	STEREO	0 : 00 : 00
and Secondary Audio Program (sub language)		SP
	SAP
broadcasts are being received simultaneously.	MONO

Select STEREO or SAP audio mode.

MTS Stereo broadcast	STOP 12 : 0 0AM	CH 02
Multi-channel Television Sound Stereo broadcast.	STEREO	0 : 00 : 00
		SP
Select STEREO audio mode.	SAP
	MONO

•If stereo broadcast is weak and display flickers, select MONO audio mode for possible better results.

SAP broadcast	STOP 12 : 0 0AM	CH 02
Secondary Audio Program (sub language) broadcast.	STEREO	0 : 00 : 00
Select SAP audio mode for the sub language.		SP
	SAP

MONO

MONO broadcast	STOP	12 : 0 0AM CH 02
Normal monaural sound broadcast.	STEREO	0 : 00 : 00
		SP
	SAP
	MONO

Equipped with ® -TV Noise Reduction for true MTS reproduction. ® -TV Noise Reduction is required for good stereo separation and audio fidelity. ® is a registered trademark, and is licensed by ® Technology Licensing.

Audio Mode for Playback

1 Start playback.

See p. 5 of “Basic Operations” Instruction book.

2 Press SAP/ Hi-Fito display audio mode. (Display disappears after 5 seconds.)

3	Press SAP/ Hi-Fi repeatedly
	to select desired mode.
H I F I : L/R
H I F I : L	• Select “HIFI(L/R)” or
H I F I : R
NORMAL
	“HIFI(L)” or “HIFI(R)” to
	listen to stereo recordings in
	stereo sound.
• Arrow indicates	Select “NORMAL” for
selection.	monaural sound.

Notes

•Only tapes recorded in Hi-Fi stereo will playback with true stereo sound. Standard stereo tapes will playback in monaural sound.

•To listen to Hi-Fi stereo playback, the VCR AUDIO (L/R) jacks must be connected to a stereo TV or an external stereo amp and speakers. (See page 4.)

•If tracking is adjusted during playback, Hi-Fi audio may revert to normal audio.

•Hi-Fi and normal audio playback volume level may differ.

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

Broadcast

- 4 - - 5 -